Negatives showing large steel parts for the mill and other steel structures that were on the Eurocan site after roughly the first 1.5 years of construction.
Negatives showing large steel parts for the mill and other steel structures that were on the Eurocan site after roughly the first 1.5 years of construction.
Negatives showing the earliest construction for the Eurocan Pulp & Paper Mill. Clearing of land and construction of dirt roads can be seen.
Notes
**IMPORTANT NOTE** - Negative slide sleeves are labelled as 2004.16.* , where * represents the item number in each series.
80001, 80003, 80004, 80006, 80011, 80013, 80017, 80045, 80047, 80052, 80054, 80058
Negatives showing the state of some of the machines and structures for the Eurocan Pulp & Paper Mill after approximately two years of site construction.
Negatives showing the state of some of the machines and structures for the Eurocan Pulp & Paper Mill after approximately two years of site construction.
Negatives showing the different stages of construction on the Eurocan wharf. Alcan can be seen in the background of some images. Two negatives are of Minette Bay where Eurocan has a stock pile of logs floating on the water and on barges.
Negatives showing the different stages of construction on the Eurocan wharf. Alcan can be seen in the background of some images. Two negatives are of Minette Bay where Eurocan has a stock pile of logs floating on the water and on barges.
John Ware was a past employee of the Kitimat Town Planning Department (1957-1959). He was hired by Hollister Kent, Planning Director for Kitimat. During his two years here, Dr. ware designed the first Kitimat street signs, the Haisla Boulevard overpass, and the Hirsch Creek Park shelter centennial project (1858-1958). He was layed off when Alcan lost major Aluminum buyers and the town expansion halted, resulting in a cut back of Kirtimat employees. He then moved to the USA.
Custodial History
Donated by John Ware.
Scope and Content
Photographs of the Haisla Boulevard pedestrian walkway bridge. Photos include bridge before centre support was installed, and after.
Notes
Further info on the walkway bridge - the pedestrian overpass was designed by John Ware to carry people, heavy wet snow loads and walkway snow plow, with a large saftey factor. The central span was designed as the maximum length of concrete double 'Tee' beam that could be carried on an open flatbed railroad car through the Canadian Rocky Mountains. The pre-stressed central span was supported on each end by poured reinforced concrete cantilevers built clear of the multi-lane highway. Initial structural calculations were done out by the very capable Kitimat Town Engineer Graydon. His calculations were checked by Kitimat's consulting engineering firm in Vancouver. Ware's design and the engineer's calculations were then sent to a pre-stressed concrete manufacturer in Calgary. When the beam arrived it was properly installed between the two cantilevers, and metal handrails were added just before the winter snow arrived. The bridge was deseigned to self support without any needed centre support. However, when city officials saw the light looking long span walkway bridge they decided that it was too fragile and that a column must be placed at mid span to give it adequate support. This decision would result in a fatal vehicle accident, as wet snows caused a driver to lose control and crash into it.
John Ware was a past employee of the Kitimat Town Planning Department (1957-1959). He was hired by Hollister Kent, Planning Director for Kitimat. During his two years here, Dr. ware designed the first Kitimat street signs, the Haisla Boulevard overpass, and the Hirsch Creek Park shelter centennial project (1858-1958). He was layed off when Alcan lost major Aluminum buyers and the town expansion halted, resulting in a cut back of Kirtimat employees. He then moved to the USA.
Custodial History
Donated by John Ware.
Scope and Content
Photographs of the Haisla Boulevard pedestrian walkway bridge concept.
Preliminary sketch design for walkway bridge over 4 lane divided highway. Designed by Jack Ware in collaboration with:
Kitimat municipal structural engineer-Bryan Graydon
Kitimat municipal structural engineering consultants-Vancouver
Note
Center prestressed beam is supported by the cantilevered beams at each end
Prestressed beam was the longest beam that could be carried on a rail flatbed car across tocky mountains in 1958
Design of supports was simplified to round columns for ease of construction
Notes
Further info on the walkway bridge - the pedestrian overpass was designed by John Ware to carry people, heavy wet snow loads and walkway snow plow, with a large saftey factor. The central span was designed as the maximum length of concrete double 'Tee' beam that could be carried on an open flatbed railroad car through the Canadian Rocky Mountains. The pre-stressed central span was supported on each end by poured reinforced concrete cantilevers built clear of the multi-lane highway. Initial structural calculations were done out by the very capable Kitimat Town Engineer Graydon. His calculations were checked by Kitimat's consulting engineering firm in Vancouver. Ware's design and the engineer's calculations were then sent to a pre-stressed concrete manufacturer in Calgary. When the beam arrived it was properly installed between the two cantilevers, and metal handrails were added just before the winter snow arrived. The bridge was deseigned to self support without any needed centre support. However, when city officials saw the light looking long span walkway bridge they decided that it was too fragile and that a column must be placed at mid span to give it adequate support. This decision would result in a fatal vehicle accident, as wet snows caused a driver to lose control and crash into it.
John Ware was a past employee of the Kitimat Town Planning Department (1957-1959). He was hired by Hollister Kent, Planning Director for Kitimat. During his two years here, Dr. ware designed the first Kitimat street signs, the Haisla Boulevard overpass, and the Hirsch Creek Park shelter centennial project (1858-1958). He was layed off when Alcan lost major Aluminum buyers and the town expansion halted, resulting in a cut back of Kirtimat employees. He then moved to the USA.
Custodial History
Donated by John Ware.
Scope and Content
Photographs of the Hirsch Creek shelter planning, construction, and completed structure.
Three black & white images show planning. One concept sketch, and two copies of a plan showing different angles of the structure.
Two colour images of construction showing interior
Two sepia images showing completed structure and view of interior
One small black & white image of near completion, with construction sacffolding on outer wall. A woman is next to it.
Four black & white images of completed roof. Woman standing on roof in one.
Ten black & white images of completed structure in winter. Sculpture is visible.
Notes
Further info on the shelter - the shelter was one of about five ideas that John Ware was asked to come up with by the Kitimat Centennial Committee. He then decided the this version would be the one to fit the build. The yellow glazed bricks were imported from Texas, even though they were ordered from a Canadian firm. He wanted a bright permanent colour that would require little maintenece. The 'sculpture' was made of pieces of triangular sheet steel on steel supports, with a colored enamel finish - similar to the original fireplace, which was red. The triangular sheets that made up the sculpture yellow and green? and intended to look like steel fir trees. The likely reason the sculpture was removed was that there was a fear if anyone climbed onto the shelter and jump down, they may impale themselves on the sharp steel.
Collection of photographs pertaining to the 1993 BC Winter Games in Kitimat. Photo content includes speakers, performances, Scouts, cake, children, Kit the Fox, signs, Mayor Rick Wozney, various other unidentified people, and possibly the opening ceremony. Photos are all attached to together in various sections. There is also one photo mounted on a blue backed mini poster. Photo is of a group of men in suits. Text on poster reads "Kitimat Winter Games 1993 Come Together You Do This I'll Do That".
Donated by Laurie Graham from the City Centre Mall Office.
Scope and Content
Collection of photographs pertaining to the 1993 BC Winter Games in Kitimat. Photo content includes speakers, performances, Scouts, cake, children, Kit the Fox, signs, Mayor Rick Wozney, various other unidentified people, and possibly the opening ceremony. Photos are all attached to together in various sections. There is also one photo mounted on a blue backed mini poster. Photo is of a group of men in suits. Text on poster reads "Kitimat Winter Games 1993 Come Together You Do This I'll Do That".
One photograph of Kitimat Night School "Talking Shop" Mrs. Rosalie Gray (teacher) and Jean Kintsos (14 May 1957). One photograph of unknown construction workers in Kitimat (no date).
Photographs taken by James Tirrul-Jones in his role as museum curator.
Scope and Content
One photograph of Kitimat Night School "Talking Shop" Mrs. Rosalie Gray (teacher) and Jean Kintsos (14 May 1957). One photograph of unknown construction workers in Kitimat (no date).
Notes
983.42.1 to 5 (Missing 2 to 4) : R51-0a and R51-4a
