A B&J camera back made out of wood. The front includes a cut out to view the ground glass. The back includes the folding focusing hood, which can be popped up and closed with pressing the latch. Around the hood has metal attachments. On The hood are markings that read "B&J MANFACTURED BY BURKE & JAMES , INC. CHICAGO, ILL. U.S.A."
A B&J camera back made out of wood. The front includes a cut out to view the ground glass. The back includes the folding focusing hood, which can be popped up and closed with pressing the latch. Around the hood has metal attachments. On The hood are markings that read "B&J MANFACTURED BY BURKE & JAMES , INC. CHICAGO, ILL. U.S.A."
Physical Condition
Poor
Material
Wood
metal
glass
leather
Condition Remarks
When opening the focusing hood there is rust chipping off.
Two copies of a black Cameralite DVY lamp. It is a small square lamp, at one side there is a switch and on the other side is the cord with a plug at the end. Underneath is a metal attachment with two screw holes and cork padding beneath, at the side there is a hand turnable screw. At the back there is brand and caution information. The lamp itself has silver metal to reflect the light from the clear glass bulb.
Two copies of a black Cameralite DVY lamp. It is a small square lamp, at one side there is a switch and on the other side is the cord with a plug at the end. Underneath is a metal attachment with two screw holes and cork padding beneath, at the side there is a hand turnable screw. At the back there is brand and caution information. The lamp itself has silver metal to reflect the light from the clear glass bulb.
A view camera. At the back there is information about the camera XXX"EASTMAN VIEW CAMERA NO.33A MADE IN U.S.A. BY EASTMAN KODAK CO. ROCHESTER, N.Y." Above it is a square cut out, most likely a view finder. At one side there is a metal dial to adjust the bellows lens. above it is a metal hand turnable screw. At the other side there is a small metal dial. At the front there is a wooden part that can be adjusted along with a piece of glass within a frame right beind it. XXXAt bottom there is a screw hole to put a tripod through it. And a hand turnable screw at side. Latch at top to allow bellows lens to extend.
A view camera. At the back there is information about the camera XXX"EASTMAN VIEW CAMERA NO.33A MADE IN U.S.A. BY EASTMAN KODAK CO. ROCHESTER, N.Y." Above it is a square cut out, most likely a view finder. At one side there is a metal dial to adjust the bellows lens. above it is a metal hand turnable screw. At the other side there is a small metal dial. At the front there is a wooden part that can be adjusted along with a piece of glass within a frame right beind it. XXXAt bottom there is a screw hole to put a tripod through it. And a hand turnable screw at side. Latch at top to allow bellows lens to extend.
Insulators are made out of green glass, and used for telephones. One has a broken bottom. Brand name "Hemingray". Used for electrical insulation of telegraphs, controlling electrical current due to their high resistivity.
Insulators are made out of green glass, and used for telephones. One has a broken bottom. Brand name "Hemingray". Used for electrical insulation of telegraphs, controlling electrical current due to their high resistivity.
A film holder from Lisco Cut. It has two dark sliders. There are markings on both sides of the film holder "5x7 LISCO CUT FILM HOLDER MADE IN U.S.A. PATENTS PENDING LISCO PRODUCTS CO. GLENDALE CALIF." "LISCO REGAL" as well as writing on white sticker paper "PORT 125"
A film holder from Lisco Cut. It has two dark sliders. There are markings on both sides of the film holder "5x7 LISCO CUT FILM HOLDER MADE IN U.S.A. PATENTS PENDING LISCO PRODUCTS CO. GLENDALE CALIF." "LISCO REGAL" as well as writing on white sticker paper "PORT 125"
Lid was used for covering mixing bowl while dough was rising. Mechanism is a piece of the bowl. It is the handle part for mixing dough by hand. Brand name " Eclipse".
Lid was used for covering mixing bowl while dough was rising. Mechanism is a piece of the bowl. It is the handle part for mixing dough by hand. Brand name " Eclipse".
Postcard addressed to Charlie Burk of Kitimat Constructors. Features image of fisherman on stream at Cascade Mountains, USA
Physical Condition
fair
Material
paper
Condition Remarks
Some creases and wear
Height
8.6 cm
Length
13.8 cm
Inscriptions
Fisherman's Paradise
This stream is typical of the many which flow down the slopes of the Cascades from which the sportsmen take thousands of fish annually - The Pacific Northwest is truly a sportsman paradise.
Pub. by Smith Scenic Views, Tacoma, Washington
Four postcards featuring images of early Kitimat and Alcan.
5 - The Townsite - Birds Eye View
6 - Camp 5 - Kemano
7 - The Kitimat Townsite
8 - The Kitimat Townsite - Mt. Elizabeth
Four postcards featuring images of early Kitimat and Alcan.
5 - The Townsite - Birds Eye View
6 - Camp 5 - Kemano
7 - The Kitimat Townsite
8 - The Kitimat Townsite - Mt. Elizabeth
Postcard featuring image the Kitimat smelter of the Aluminum Company of Canada, Limited.
Physical Condition
Fair
Material
paper
Condition Remarks
Corners a little worn, image shows fine scratching, back a bit dirty
Height
9cm
Width
14cm
Inscriptions
Back of postcard read: KITIMAT WORKS - B.C. The Kitimat smelter of the Aluminum Company of Canada, Limited. Installed capacity - 192,000 tons per year.
Picture postcard showing an aerial view of the Nechako neighbourhoods under construction. In the foreground of the photo are Ptarmigan, Plover, Pintail, and Partridge streets. Behind them to the right are some trees, and to the left is an empty area where Nechako School would later be built. In the background runs Nalabila Blvd. with some of the curved streets (Starling, Swallow) running off of it. A black mark has been drawn near the upper middle of the card, indicating where the sender lived (at the 'curve' of Starling Street').
Message from sender (possibly Mike or Nancy Marciniak) on back:
"This picture of Townsite was taken last year, now the whole area is nearly filled with houses. I live near the centre where the cross is.
Three years ago this was all forest, the same as you see all around the edge of the town."
Picture postcard showing an aerial view of the Nechako neighbourhoods under construction. In the foreground of the photo are Ptarmigan, Plover, Pintail, and Partridge streets. Behind them to the right are some trees, and to the left is an empty area where Nechako School would later be built. In the background runs Nalabila Blvd. with some of the curved streets (Starling, Swallow) running off of it. A black mark has been drawn near the upper middle of the card, indicating where the sender lived (at the 'curve' of Starling Street').
Message from sender (possibly Mike or Nancy Marciniak) on back:
"This picture of Townsite was taken last year, now the whole area is nearly filled with houses. I live near the centre where the cross is.
Three years ago this was all forest, the same as you see all around the edge of the town."
Physical Condition
Fair
Material
paper
Condition Remarks
Some creases in postcard, especially at upper and lower right-hand corners. All corners have been worn down. Back of the card is yellowed and has some smudges and stains on it, including a brown teardrop-shaped stain below the "Put Stamp Here" label.
Width
8.5 cm
Length
13.7 cm
Inscriptions
"THE TOWNSITE" BIRDS EYE VIEW Kitimat, B.C., Canada
P9733
Published for The Hudson's Bay Company, Canada
Plastichrome (R) by COLOURPICTURE PUBLISHERS, INC., Boston 15, Mass., U.S.A.
Reproduced from 35MM Transparency
Date Range
[1955]
Accession Number
2014.13.39
Biographical Notes
Nancy Anne Hickinbottom was born in Kitimat in 1957 to Mike (Miecyszlaw) and Nancy Marciniak, who lived in the town during its early days.
Postcard featuring aerial view of Nechako neighbourhood, with focus on Petrel, Plover, Partridge, and Pintail streets. Houses and neighbourhoods still under construction.
Postcard featuring aerial view of Nechako neighbourhood, with focus on Petrel, Plover, Partridge, and Pintail streets. Houses and neighbourhoods still under construction.
Physical Condition
good
Material
paper
Height
8.3 cm
Length
13.8 cm
Inscriptions
"The Townsite" Birds Eye View
Kitimat, B.C., Canada
Published for The Hudson's Bay Company, Canada
Reproduced from 35MM Transparency
Postcard featuring aerial view of Alcan smeltersite and potlines.
Physical Condition
good
Material
paper
Height
8.9 cm
Length
13.8 cm
Inscriptions
Aerial View of Aluminum Company of Canada's Smelter Site
Kitimat, B.C., Canada
Published for The Hudson's Bay Company, Canada
Reproduced from 35MM Transparency
